Best Choice Similar to A*DON&Q*EST NBSEROL 500-600PPD Dehumidifier - Trusted China Suppliers & Factory
Ultrasonic atomization humidifier adopts electronic OVERfrequency shock, high frequency resonance of atomization piece, water is thrown off the surface and produce natural and elegant water mist, without heating or chemical agent. Internal use of integrated atomization movement, no mechanical drive, quiet, no noise, high atomization efficiency, low failure rate, simple maintenance, the machine output fog particle diameter of 1 ~ 10μ , the maximum relative humidity can reach 90%±5%.
Humidifier atomization work can not only maintain the humidity required by the environment, reduce the harmful substances suspended in the air to reduce static electricity, but also produce a certain concentration of negative oxygen ions, so that the air purification, improve the dry commercial or industrial environment.
Technical Parameters
The machine model |
XH-809C |
XH-812C |
Humidification quantity |
9-18L/H |
12-24L/H |
The power supply |
220V/50Hz |
220V/50Hz |
power |
900W |
1200W |
The weight of the |
30KG |
35KG |
The power supply |
220V |
220V |
Installation Diagram And Installation Precautions
During installation, in order to avoid short circuit caused by the influence of water mist and affect the life of the machine, the machine needs to be placed outdoors and connected to the indoor pipe. The ultrasonic humidifier has one, two or three fog outlets with a diameter of 110mm or 160mm. The height of the connecting pipe shall not exceed 3m, and the length shall not exceed 15m.
Plug the outlet after connecting the fog pipe, and then punch a hole on the side of the pipe to make the water mist come out through the fog hole. There is no special requirement for the distance of the hole. The size of the fog hole can be controlled at 2-3cm, and the spacing is about 40-50 cm (can be adjusted according to the situation). The slightly higher end of the pipe also facilitates the flow of water formed inside the pipe back into the tank. The sensor is inserted and placed in a place where the ambient water spray will not be directly sprayed. The end can be equipped with plug or not plug according to the use requirements.
Ultrasonic humidifier itself has the function of automatic water, can be directly connected to the water pipe, water pipe specifications are 4. The water pressure should not be lower than 80Pa. Under normal circumstances, ordinary tap water can be used. If the local water quality is poor, it is recommended to install a water purifier. The device should be installed horizontally. The fog pipe should be sealed to prevent air leakage and water leakage. If the external water supply pressure is insufficient, connect an external water pump to ensure that the water supply pressure ranges from 0.1 MPa to 0.3MPa
Failure Analysis
Frequently Asked Questions (FAQ)
The humidifier uses electronic overfrequency shock and high-frequency resonance of the atomization piece to throw water off the surface, producing a natural and elegant water mist without heating or using chemical agents.
The output fog particle diameter ranges from 1 to 10μm, and the machine can achieve a maximum relative humidity of up to 90%±5%.
The connection pipe should have a diameter of 110mm or 160mm. The vertical height of the pipe must not exceed 3 meters, and the overall length should not exceed 15 meters.
This typically occurs when there is too much water in the tank. Open the drain valve to drain a portion of the water to resolve the issue.
The humidifier supports automatic water feeding via a water pipe (specification size 4). Water pressure should not be lower than 80Pa. If the external water pressure is insufficient, connect a pump to maintain a pressure range of 0.1 MPa to 0.3 MPa.
First, check if the drain valve is fully closed. Second, ensure that the inlet pipe connector is securely connected. Finally, check and securely connect the water softener using special tools.